Re: mill
Posted by
Al Schoepp
on 2000-01-13 10:12:25 UTC
oops, forgot the info the mill I was asking about
Bridge Port Series II, Interact 4 milling machine (made in UK). 415
volt, 3 phase, 50 Hz, full load current 25, spindle motor current 22,
control voltage 110, fuse interupt cap 20. Unit measures approx 6' L x
4' W x 7' H. Includes video display control and light on swing arm. Item
was serviceable, may not be complete.
Al Schoepp wrote:
Bridge Port Series II, Interact 4 milling machine (made in UK). 415
volt, 3 phase, 50 Hz, full load current 25, spindle motor current 22,
control voltage 110, fuse interupt cap 20. Unit measures approx 6' L x
4' W x 7' H. Includes video display control and light on swing arm. Item
was serviceable, may not be complete.
Al Schoepp wrote:
>
> From: Al Schoepp <a_schoep@...>
>
> I've been looking for a milling machine for a home shop for a while. I
> just found this going up for auction (military surplus). I realize it
> is way overkill for a home shop but if I could get it for the right
> price... I looked for some info on the machine on the web with no luck,
> does anyone here have any info on it, or thoughts about it's usefulness
> in a small shop. If it's possible to convert to 220v or run 415v in the
> home.
>
> Al
>
> --------------------------- ONElist Sponsor ----------------------------
>
> GRAB THE GATOR! FREE SOFTWARE DOES ALL THE TYPING FOR YOU!
> Tired of filling out forms and remembering passwords? Gator fills in
> forms and passwords with just one click! Comes with $50 in free coupons!
> <a href=" http://clickme.onelist.com/ad/gator4 ">Click Here</a>
>
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
Discussion Thread
Al Schoepp
2000-01-13 09:01:20 UTC
mill
Al Schoepp
2000-01-13 10:12:25 UTC
Re: mill
PTENGIN@x...
2000-01-13 10:25:34 UTC
Re: mill
Darrell
2000-01-13 10:40:27 UTC
Re: mill
Charles VanLeeuwen
2000-01-13 13:26:05 UTC
Re: mill
Steve Carlisle
2000-01-13 18:40:51 UTC
Re: mill
Darrell
2000-01-13 17:24:05 UTC
Re: mill
Steve Carlisle
2000-01-13 18:55:27 UTC
Re: mill
Jon Elson
2000-01-13 23:09:54 UTC
Re: mill
Paul Corner
2000-01-14 11:48:15 UTC
Re: mill