CAD CAM EDM DRO - Yahoo Group Archive

Re: Servos/help

Posted by dakota8833
on 2002-06-17 17:30:24 UTC
--- In CAD_CAM_EDM_DRO@y..., "RC" <asdf@c...> wrote:
> Frank, if you don't mind sharing with us, what does your servo
system
> consist of? I too would like to build a servo system for the same
reasons,
> and any information would be very helpful in getting me started.....
>
> RC
> ----- Original Message -----
> From: dakota8833 <dakota8833@b...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Friday, June 14, 2002 7:44 AM
> Subject: [CAD_CAM_EDM_DRO] Servos
>
>


I am running a 500 Celaron cpu with 128v meg.Vidio board is ATI. The
servo motors are globe 190 inch oz from Camtronics. I am currently
running at 600 ipm rapid. Milling at about 400 ipm. Steps per inch is
2048. Do the math. My controller hardware is Gecko 3xx. Software is
EMC,.... free constant contouring software. Feel free to ask any other
questions, I am more than happy to help. Call me at 850 722 7713 and
after 9 pm central time I can return calls free to me in the US.

Frank

Discussion Thread

Jon Elson 2000-11-02 16:17:41 UTC Re: Servos Ian Wright 2001-08-21 03:28:53 UTC Servos Jon Elson 2001-08-21 09:19:35 UTC Re: [CAD_CAM_EDM_DRO] Servos Ian Wright 2001-08-21 09:48:58 UTC Re: [CAD_CAM_EDM_DRO] Servos dakota8833 2002-06-14 07:44:15 UTC Servos RC 2002-06-14 13:36:57 UTC Re: [CAD_CAM_EDM_DRO] Servos dakota8833 2002-06-17 17:30:24 UTC Re: Servos/help machinist24540 2002-11-08 11:38:05 UTC Servos Mark 2002-11-08 22:22:59 UTC Re: Servos Jon Elson 2002-11-08 23:03:18 UTC Re: [CAD_CAM_EDM_DRO] Servos William Scalione 2002-11-11 11:50:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Servos