Re: Motor
Posted by
mariss92705
on 2002-07-13 20:41:00 UTC
Gene,
Your'e right on both counts. The motor runs cooler in series as well.
Use series if you don't have to have high speed. Low speed torque
will be the same.
Mariss
Your'e right on both counts. The motor runs cooler in series as well.
Use series if you don't have to have high speed. Low speed torque
will be the same.
Mariss
--- In CAD_CAM_EDM_DRO@y..., Gene <capper@i...> wrote:
> What is the difference between connecting a 8 wire motor either
> parallel or series? If you use series then do you use 1/2 rated
amps?
> Is there lower speed and power in series?
Discussion Thread
Mike Snodgrass
2002-03-05 12:02:18 UTC
Motor
mariss92705
2002-03-05 17:36:17 UTC
Re: Motor
Gene
2002-07-13 19:24:04 UTC
Motor
mariss92705
2002-07-13 20:41:00 UTC
Re: Motor
turbulatordude
2002-09-03 07:02:55 UTC
Speed - Parallel vs serial ( was Re: Motor
Robert Campbell
2002-09-03 07:19:23 UTC
Re: [CAD_CAM_EDM_DRO] Speed - Parallel vs serial ( was Re: Motor
turbulatordude
2002-09-03 16:36:21 UTC
Speed - Parallel vs serial ( was Re: Motor
Bob Simon
2002-09-03 19:32:21 UTC
Siemens drives in current mode
Robert Campbell
2002-09-03 19:36:21 UTC
Re: [CAD_CAM_EDM_DRO] Speed - Parallel vs serial ( was Re: Motor
cadcamcenter
2002-09-03 21:41:06 UTC
Speed - Parallel vs serial ( was Re: Motor
cadcamcenter
2002-09-03 21:57:29 UTC
Speed - Parallel vs serial ( was Re: Motor
turbulatordude
2002-09-04 04:35:15 UTC
8 wire half or Serial ? ( was Speed - Parallel vs serial ( was Re: Motor
mariss92705
2002-09-04 07:35:13 UTC
8 wire half or Serial ? ( was Speed - Parallel vs serial ( was Re: Motor
turbulatordude
2002-09-04 11:01:43 UTC
8 wire half or Serial ? ( was Speed - Parallel vs serial ( was Re: Motor
cadcamcenter
2002-09-04 17:07:47 UTC
8 wire half or Serial ? ( was Speed - Parallel vs serial ( was Re: Motor
JJ
2002-09-04 17:35:24 UTC
RE: [CAD_CAM_EDM_DRO] Speed - Parallel vs serial ( was Re: Motor
cadcamcenter
2002-09-04 19:06:10 UTC
Speed - Parallel vs serial ( was Re: Motor
JJ
2002-09-05 04:12:04 UTC
RE: [CAD_CAM_EDM_DRO] Speed - Parallel vs serial ( was Re: Motor
turbulatordude
2002-09-05 04:25:36 UTC
Speed - Parallel vs serial ( was Re: Motor