Re: [CAD_CAM_EDM_DRO] another EMC Glitch?

Thanks bill, I will change my post processor to end with M02 and see what
happens.
When I am doing these wood signs each one is a different thickness so
I have to re offset. When I do a batch the same thickness I will try
ending with a % or M00. I use M00 quite effectively for a tool change.
I just hit resume to continue.

Les
Leslie Watts
L M Watts Furniture
Tiger, Georgia USA
http://www.alltel.net/~leswatts/wattsfurniturewp.html
engineering page:
http://www.alltel.net/~leswatts/shop.html

----- Original Message -----
From: "William Scalione" <wscalione@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, July 13, 2002 11:41 PM
Subject: Re: [CAD_CAM_EDM_DRO] another EMC Glitch?


> Les,
>
> I always used M02 to end the program and on the old versions
> of EMC the offsets never went away at the end of the program.
> By old versions I mean the ones that ran under RH 5.2 Then the
> glitch got somehow worked into it after it was ported to RH 6.0.
> I don't think the port to 6.0 did it, but it showed up sometime after
> that.
>
> I did some experimenting on my system and using M02 to end
> the program would ALWAYS result in the offsets being lost, but at
> least the gui reflects it with everything going back to zero. Once
> I left the M02 off the end of the program, it worked the way I thought
> it should work. by remembering the offsets.