Re: A Question to MARISS
Posted by
mariss92705
on 2002-07-31 11:09:20 UTC
Raul,
Try touching off the plasma thing with the parallel port cable
disconnected at the PC end and the drive powered up. See if the motor
moves or creeps. If it does not, then the problem is with the PC. You
might want to use a line RFI filter on your PC and drive power supply
115VAC input lines. Corcom comes to mind as filter source.
Let me know what you find.
Mariss
Try touching off the plasma thing with the parallel port cable
disconnected at the PC end and the drive powered up. See if the motor
moves or creeps. If it does not, then the problem is with the PC. You
might want to use a line RFI filter on your PC and drive power supply
115VAC input lines. Corcom comes to mind as filter source.
Let me know what you find.
Mariss
--- In CAD_CAM_EDM_DRO@y..., "ralaco" <ralaco@y...> wrote:
> Dear Mariss:
>
> I already connected pin 1 from game port to get the 5 volts.
>
> STEP, DIRECTION and +5VDC are already shielded and grounded to pin
25
> from parallel port.
> Every other cables from limits and joystick are disconnected from
the
> PC.
> I'm still getting noise.
>
> What else can I try?
>
> Best regards
>
> Raul
Discussion Thread
Raul Lara
2002-07-30 11:53:19 UTC
A Question to MARISS
Peter
2002-07-30 13:13:09 UTC
Re: [CAD_CAM_EDM_DRO] A Question to MARISS
turbulatordude
2002-07-30 16:43:02 UTC
Re: A Question to MARISS
mariss92705
2002-07-30 18:16:14 UTC
Re: A Question to MARISS
mariss92705
2002-07-30 18:22:21 UTC
Re: A Question to MARISS
Peter
2002-07-30 19:24:08 UTC
Re: electrical noise - was Re: A Question to MARISS
Jon Elson
2002-07-30 19:57:30 UTC
Re: [CAD_CAM_EDM_DRO] A Question to MARISS
ralaco
2002-07-31 09:37:14 UTC
Re: A Question to MARISS
mariss92705
2002-07-31 11:09:20 UTC
Re: A Question to MARISS
ralaco
2002-07-31 16:02:04 UTC
Re: A Question to MARISS
ralaco
2002-07-31 16:03:07 UTC
Re: A Question to MARISS