CAD CAM EDM DRO - Yahoo Group Archive

Re: stepless in New Jersey

Posted by caudlet
on 2002-08-09 16:47:01 UTC
--- In CAD_CAM_EDM_DRO@y..., "turbulatordude" <davemucha@j...> wrote:
> Hi all,
>
> I need a little break.
>
>
> OK, oh wise ones, what am I doing wrong ? er... how best to get
> this puppy to respond to software ?
>
> Dave

See my earlier posts over the last few days about Parallel Port
Woes. If you can force steps from the Gecko then you can rule out
motors, power supply and the Gecko drives. You are then left with
the signal from the PC, the cables (not likely)or the parallel port.
If the port does not have enough "pookey" to turn on the
optoisolators then nothing will happen.

Discussion Thread

turbulatordude 2002-08-09 10:24:35 UTC stepless in New Jersey Dan Statman 2002-08-09 10:39:30 UTC Re: [CAD_CAM_EDM_DRO] stepless in New Jersey turbulatordude 2002-08-09 10:57:51 UTC Re: stepless in New Jersey turbulatordude 2002-08-09 10:59:20 UTC Re: stepless in New Jersey William Scalione 2002-08-09 11:32:07 UTC Re: [CAD_CAM_EDM_DRO] Re: stepless in New Jersey caudlet 2002-08-09 16:47:01 UTC Re: stepless in New Jersey caudlet 2002-08-09 16:58:10 UTC Re: stepless in New Jersey turbulatordude 2002-08-09 19:47:11 UTC stepping in NJ ( was Re: stepless in New Jersey JJ 2002-08-11 11:37:50 UTC RE: [CAD_CAM_EDM_DRO] stepless in New Jersey