8 wire steppers ( was Re: Confused over My own Calculations!
Posted by
turbulatordude
on 2002-08-19 06:11:38 UTC
<snip>
when series.
5A nameplate = 5A when parallel and 2.5A when in series.
Any over amping a motor is just waste. a very slight increase in low
end torque, but a huge increase in heat negating any real benefit.
> The nameplate rating is the max. per winding, which is also thenominal current
> for full rated torque. But, an 8-wire motor complicates thesituation.
> The nameplate rating is for unipolar or bipolar series connection.I thought 8 wire steppers were FLA when parallel and half nameplate
> You double the current when using the windings in parallel.
when series.
5A nameplate = 5A when parallel and 2.5A when in series.
Any over amping a motor is just waste. a very slight increase in low
end torque, but a huge increase in heat negating any real benefit.
Discussion Thread
mayfieldtm
2002-08-17 13:42:20 UTC
Confused over Mariss's Calculations
mayfieldtm
2002-08-17 14:07:25 UTC
Confused over My own Calculations!
turbulatordude
2002-08-17 20:03:03 UTC
Re: Confused over My own Calculations!
mayfieldtm
2002-08-18 00:03:06 UTC
Re: Confused over My own Calculations!
Jon Elson
2002-08-18 10:52:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: Confused over My own Calculations!
mayfieldtm
2002-08-18 13:24:06 UTC
Re: Confused over My own Calculations!
Jon Elson
2002-08-18 13:39:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Confused over My own Calculations!
mariss92705
2002-08-18 17:07:03 UTC
Re: Confused over My own Calculations!
William Scalione
2002-08-18 17:49:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Confused over My own Calculations!
mariss92705
2002-08-18 18:36:41 UTC
Re: Confused over My own Calculations!
Jon Elson
2002-08-18 20:33:07 UTC
Re: [CAD_CAM_EDM_DRO] Re: Confused over My own Calculations!
William Scalione
2002-08-19 00:35:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Confused over My own Calculations!
turbulatordude
2002-08-19 06:11:38 UTC
8 wire steppers ( was Re: Confused over My own Calculations!