CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Getting Started with Servo CNC

Posted by wanliker@a...
on 2002-09-09 19:23:50 UTC
In a message dated 9/9/2002 5:47:50 PM Mountain Daylight Time,
ereikes@... writes:


> Also, any similar programs that are sset
> up for lathe CAM?

You might want to look at TurboCNC, it was designed around lathe work, and is
being improved all the time, with more features. Price is around $20, and
includes the source code, and there others helping to improve it, and you can
do so also if you desire.
http://www.dakeng.com/
There is also a group on Yahoo designated to this software.
bill


[Non-text portions of this message have been removed]

Discussion Thread

erikreikes 2002-09-09 16:46:51 UTC Getting Started with Servo CNC bsptrades 2002-09-09 18:58:09 UTC Re: Getting Started with Servo CNC wanliker@a... 2002-09-09 19:23:50 UTC Re: [CAD_CAM_EDM_DRO] Getting Started with Servo CNC wanliker@a... 2002-09-09 19:58:29 UTC Re: [CAD_CAM_EDM_DRO] Getting Started with Servo CNC wayne_j_hill 2002-09-09 21:55:36 UTC Re: Getting Started with Servo CNC Erik Reikes 2002-09-10 00:12:16 UTC Re: Getting Started with Servo CNC Fred Smith 2002-09-10 09:30:06 UTC Re: Getting Started with Servo CNC Dan Mauch 2002-09-10 10:55:08 UTC RE: [CAD_CAM_EDM_DRO] Getting Started with Servo CNC Erik Reikes 2002-09-10 14:59:19 UTC Re: Getting Started with Servo CNC Dan Mauch 2002-09-12 09:19:28 UTC RE: [CAD_CAM_EDM_DRO] Re: Getting Started with Servo CNC Dan Mauch 2002-09-13 09:40:18 UTC Multiple Operating Systems mgdcnc 2002-09-13 21:19:23 UTC Re: Getting Started with Servo CNC jeffdavis516 2002-09-14 08:47:10 UTC Re: Getting Started with Servo CNC mgdcnc 2002-09-15 00:10:52 UTC Re: Getting Started with Servo CNC