Re: [CAD_CAM_EDM_DRO] 60oz. stepper motors!
Posted by
Jon Elson
on 2002-09-09 21:25:40 UTC
jepps5 wrote:
doubts that this motor could move A Series-I Bridgeport without any cutting
faster than 10 IPM or so. If you have a Sherline, I doubt you can mill stainless
anyway. The problem is that stepper motors lose their torque rapidly as speed
increases. If you have 60 In-Oz of holding torque, you might have only 20 In-Oz
of driving torque at 300 RPM.
Jon
> Would 60oz. stepper motors be enough to mill stainless steel? I knowWhat size machine do you have? With a 5 TPI Acme screw, I would have
> that everybody has big motors here but I dont have that much money
> to spend. I was wondering if I could just use slow feed rates to cut
> stainless steel with these stepper motors.
doubts that this motor could move A Series-I Bridgeport without any cutting
faster than 10 IPM or so. If you have a Sherline, I doubt you can mill stainless
anyway. The problem is that stepper motors lose their torque rapidly as speed
increases. If you have 60 In-Oz of holding torque, you might have only 20 In-Oz
of driving torque at 300 RPM.
Jon
Discussion Thread
jepps5
2002-09-09 02:35:08 UTC
60oz. stepper motors!
John Guenther
2002-09-09 05:27:54 UTC
RE: [CAD_CAM_EDM_DRO] 60oz. stepper motors!
jepps5
2002-09-09 09:46:17 UTC
Re: 60oz. stepper motors!
j.guenther
2002-09-09 10:04:53 UTC
RE: [CAD_CAM_EDM_DRO] Re: 60oz. stepper motors!
dodge1320
2002-09-09 16:41:10 UTC
Re: 60oz. stepper motors!
dodge1320
2002-09-09 17:28:20 UTC
Re: 60oz. stepper motors!
Ray Henry
2002-09-09 20:39:22 UTC
Re: RE: Re: 60oz. stepper motors!
Jon Elson
2002-09-09 21:25:40 UTC
Re: [CAD_CAM_EDM_DRO] 60oz. stepper motors!
jepps5
2002-09-09 22:27:03 UTC
Re: 60oz. stepper motors!
Steve Blackmore
2002-09-10 00:30:36 UTC
Re: [CAD_CAM_EDM_DRO] 60oz. stepper motors!
Jon Elson
2002-09-10 21:56:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: 60oz. stepper motors!