Re: machine setup for rotary table

--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:

> Note it is G201 drives so 10 microsteps. Works out to .0025 degrees

per

> step. I would say that he is a candidate for a G901 board to make

his drive

> into a G210.

I had originally set it up for 5 deg. per step. (sheepish).

Now with 0.0025 deg per step, it is moving as it should.

Max speed was 5000
Max accel.: 500
start vel: 500

The accel profile was probably set too low. Any suggestions. Wish
G901 was an external board.

Peter