Re: [CAD_CAM_EDM_DRO] machine setup for rotary table
Posted by
Dan Statman
on 2002-09-18 21:18:32 UTC
Although I have never used another controller. I believe they are usually
setup as degrees per minute on angular feedrates, so it wasn't stupid at
all.
Daniel J. Statman, Statman Designs
www.statmandesigns.com
setup as degrees per minute on angular feedrates, so it wasn't stupid at
all.
Daniel J. Statman, Statman Designs
www.statmandesigns.com
----- Original Message -----
From: "John Guenther" <j.guenther@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, September 18, 2002 9:14 PM
Subject: RE: [CAD_CAM_EDM_DRO] machine setup for rotary table
> Ok, so the mind was not engaged when the fingers typed that stupid
statement
> in my original reply. I stand corrected.
>
> John
>
Discussion Thread
cncuni2002
2002-09-18 17:40:27 UTC
machine setup for rotary table
Dan Statman
2002-09-18 18:01:13 UTC
Re: [CAD_CAM_EDM_DRO] machine setup for rotary table
John Guenther
2002-09-18 18:01:24 UTC
RE: [CAD_CAM_EDM_DRO] machine setup for rotary table
Dan Statman
2002-09-18 18:06:37 UTC
Re: [CAD_CAM_EDM_DRO] machine setup for rotary table
John Guenther
2002-09-18 18:13:23 UTC
RE: [CAD_CAM_EDM_DRO] machine setup for rotary table
Tim Goldstein
2002-09-18 18:49:59 UTC
RE: [CAD_CAM_EDM_DRO] machine setup for rotary table
Tim Goldstein
2002-09-18 18:50:21 UTC
RE: [CAD_CAM_EDM_DRO] machine setup for rotary table
Dan Statman
2002-09-18 21:18:32 UTC
Re: [CAD_CAM_EDM_DRO] machine setup for rotary table
turbulatordude
2002-09-19 03:11:35 UTC
TurboCNC and Re: machine(software) setup for rotary table
Tim Goldstein
2002-09-19 10:21:54 UTC
Re: [CAD_CAM_EDM_DRO] machine setup for rotary table
cncuni2002
2002-09-19 15:40:32 UTC
Re: machine setup for rotary table