CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Question on power supply

on 2002-09-23 20:20:29 UTC
Hi Jim,

Should be fine for motors!

Alan KM6VV

Jim wrote:
>
> Thank you Alan for your suggestion I'll try that. Another thing with
> this power supply is that it has a +/- 10% ripple voltage. Should I
> be concerned with that or not?
>

Discussion Thread

Keith Bowers 2002-09-23 19:08:40 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply Alan Marconett KM6VV 2002-09-23 19:22:11 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply Jim 2002-09-23 19:37:33 UTC Question on power supply dazedNconfused 2002-09-23 20:17:30 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply Alan Marconett KM6VV 2002-09-23 20:20:29 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply Peter 2002-09-23 20:27:21 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply dazedNconfused 2002-09-23 20:33:02 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply Tim Goldstein 2002-09-23 21:20:16 UTC RE: [CAD_CAM_EDM_DRO] Question on power supply Jon Elson 2002-09-23 22:13:14 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply Jon Elson 2002-09-23 22:18:33 UTC Re: [CAD_CAM_EDM_DRO] Question on power supply