Re: Gecko Reset/Manager Again
Posted by
dakota8833
on 2002-10-07 06:08:25 UTC
--- In CAD_CAM_EDM_DRO@y..., Ray Henry <rehenry@u...> wrote:
normal , 0 volts when faulted. But with this Gecko Reset/Manager
circuit hooked up I only read 3.51 volts. Still get 0 v on a fault and
4.80 v pushing the reset switch.
Frank
>laptops. Is
> I've heard of low parport voltages like this being common to
> that also true of newer motherboards with low voltage processors?on
>
> Ray
>
> > Â Â From: "dakota8833" <dakota8833@b...>
> > Subject: Gecko Reset/Manager Again
> >
> > Well the circuit is up and running. But a noticed only 3.51 volts
> > the ERROR pins. Mariss states a voltage lower than 3.25 will faultthe
> > drives ( pull all to 0 volts ). I thought I should see at least 5,
> > volts here. .25 volts is cutting it close. Had some random faults
> > mostly during PC boot up. Anyone build this circuit, does it workThe voltage reading was taken from the Geckos ERR/RES pin. 5 volts
> > correctly ??
> >
> > Frank
normal , 0 volts when faulted. But with this Gecko Reset/Manager
circuit hooked up I only read 3.51 volts. Still get 0 v on a fault and
4.80 v pushing the reset switch.
Frank
Discussion Thread
dakota8833
2002-10-06 17:26:51 UTC
Gecko Reset/Manager Again
Ray Henry
2002-10-07 05:24:52 UTC
Re: Gecko Reset/Manager Again
dakota8833
2002-10-07 06:08:25 UTC
Re: Gecko Reset/Manager Again
alan@s...
2002-10-07 09:20:33 UTC
Re: Gecko Reset/Manager Again