Re: Hand wheels and Geckos
Posted by
vrsculptor
on 2002-10-07 05:53:05 UTC
> Question when you turn off the power supply to use the millmanually, is
> there a problem with having it back feed energy back into thedrives by
> turning the hand wheels?parallel or
> Will this hurt the drives? Would it matter if the stepper is in
> series?Derek,
I asked this last year on servos and Gecko's and the answer from
Marris et all was no problem.
Roger
Discussion Thread
Brent Fuchs
2002-10-06 18:38:23 UTC
PID setting in EMC
mariss92705
2002-10-06 19:47:45 UTC
Re: PID setting in EMC
Tim Goldstein
2002-10-06 20:02:34 UTC
RE: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
High Tech
2002-10-06 23:14:16 UTC
Hand wheels and Geckos
Ray Henry
2002-10-07 05:24:56 UTC
Re: PID setting in EMC
vrsculptor
2002-10-07 05:53:05 UTC
Re: Hand wheels and Geckos
dakota8833
2002-10-07 06:31:31 UTC
Re: PID setting in EMC
Rick E
2002-10-07 07:47:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
Tim Goldstein
2002-10-07 09:35:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
skykotechnologies
2002-10-07 09:54:10 UTC
Re: PID setting in EMC
Rick E
2002-10-07 12:16:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
William Scalione
2002-10-07 13:53:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC