Re: [CAD_CAM_EDM_DRO] EMC questions

EMC does both depending. In steppermod.o mode it is pure open loop. In
freqmod.o it dummies the feedback for a closed loop.

I have used the generic monitor. Proceed at your own risk.

Tim
[Denver, CO]

----- Original Message -----

> Hi,
> I'm unclear about how EMC drives a open loop step/dir interface.
> Is there an open loop configuration or does it just dummy out the
> feedback loop in software?
> So I thought I would just try installing it and see what happens,
> but the BDI install isn't detecting my monitor type. It's asking for
> the nearest type, or else to enter the horizontal and vertical
> refresh rates, as if I would know. Does anyone know of a safe choice
> to enter here ? Thanks for any hints.
>
> Rob
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........