vexta stepper/driver
Posted by
Zafar Salam
on 2002-10-23 22:31:29 UTC
Hi all,
Going through the old posts here, I noticed that a few members are using the vexta 5-phase steppers/drivers. I have my eyes on a set of Super Vexta drivers and vexta PH599H-A steppers that are going cheep. Could you guide me on their performance and which software are you using to drive them. These are 0.72 degrees and 2.4A Nema 32 motors. I couldn't find the specs of the motors on the web. Oriental motors web site doesn't seem to have these numbers. Is there any other place should I look in.
Regards,
Zafar
[Non-text portions of this message have been removed]
Going through the old posts here, I noticed that a few members are using the vexta 5-phase steppers/drivers. I have my eyes on a set of Super Vexta drivers and vexta PH599H-A steppers that are going cheep. Could you guide me on their performance and which software are you using to drive them. These are 0.72 degrees and 2.4A Nema 32 motors. I couldn't find the specs of the motors on the web. Oriental motors web site doesn't seem to have these numbers. Is there any other place should I look in.
Regards,
Zafar
[Non-text portions of this message have been removed]
Discussion Thread
Zafar Salam
2002-10-23 22:31:29 UTC
vexta stepper/driver
Lloyd Leung
2002-10-24 00:21:25 UTC
RE: [CAD_CAM_EDM_DRO] vexta stepper/driver
tommoser3246
2002-10-24 06:32:47 UTC
Re: vexta stepper/driver
Jon Elson
2002-10-24 09:33:06 UTC
Re: [CAD_CAM_EDM_DRO] vexta stepper/driver
Alan Marconett KM6VV
2002-10-24 11:52:52 UTC
Re: [CAD_CAM_EDM_DRO] vexta stepper/driver
Zafar Salam
2002-10-24 19:14:35 UTC
Re: [CAD_CAM_EDM_DRO] vexta stepper/driver