Re: [CAD_CAM_EDM_DRO] vexta stepper/driver

Hi Zafar,

You might want to check, The 5-phase Vexta I have is CW/CCW, and 100V.
Yes, I ran it off a VARIAC, and made a special version of my controller
program to do CW/CCW. Some glue logic could probably also convert
step/dir to CW/CCW. The NEMA #34 was a little big for my uses.

Alan KM6VV

Zafar Salam wrote:

>
> Hi all,
> Going through the old posts here, I noticed that a few members are using the vexta 5-phase steppers/drivers. I have my eyes on a set of Super Vexta drivers and vexta PH599H-A steppers that are going cheep. Could you guide me on their performance and which software are you using to drive them. These are 0.72 degrees and 2.4A Nema 32 motors. I couldn't find the specs of the motors on the web. Oriental motors web site doesn't seem to have these numbers. Is there any other place should I look in.
>
> Regards,
> Zafar