Re: Help a confused newbie out please
Posted by
caudlet
on 2002-11-12 05:43:12 UTC
--- In CAD_CAM_EDM_DRO@y..., "jagco1998" <jagco1998@y...> wrote:
familiar with (Mach1, MicroKinetics, Master5) only do
acceleration/deacceleration on step commands, not e-stop or limit.
> I am quite new to CNC and was curious if I wired switches at theThat would be the function of the Controller Program. The one's I am
> limits of each axiis travel and have the software setup to ramp the
> acceleration up/down........Would the motors stop suddenly when the
> limit switch is activated and an Estop is instructed?
> Or would the motors ramp the motors down to a stop when the switch
> is hit, thus crushing the switch and possibly warping my new
> ballscrews or worse?
> What is the correct way of setting up limit switches?
>
> Thanks in advance.
> Regards,
> Jim
familiar with (Mach1, MicroKinetics, Master5) only do
acceleration/deacceleration on step commands, not e-stop or limit.
Discussion Thread
jagco1998
2002-11-11 20:42:44 UTC
Help a confused newbie out please
caudlet
2002-11-12 05:43:12 UTC
Re: Help a confused newbie out please
JJ
2002-11-12 06:03:01 UTC
RE: [CAD_CAM_EDM_DRO] Help a confused newbie out please
Carol & Jerry Jankura
2002-11-12 06:43:20 UTC
RE: [CAD_CAM_EDM_DRO] Help a confused newbie out please
egroupscdh@W...
2002-11-12 07:10:49 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
Jim Brown
2002-11-12 08:34:12 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
Carol & Jerry Jankura
2002-11-12 09:42:06 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
egroupscdh@W...
2002-11-12 10:41:29 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
Alan Marconett KM6VV
2002-11-12 11:09:51 UTC
Re: Help a confused newbie out please
caudlet
2002-11-12 12:37:48 UTC
Re: Help a confused newbie out please
Jim Brown
2002-11-12 12:55:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
Alan Marconett KM6VV
2002-11-12 13:28:22 UTC
Re: Help a confused newbie out please
caudlet
2002-11-12 14:29:12 UTC
Re: Help a confused newbie out please
egroupscdh@W...
2002-11-12 14:51:12 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
Jim Brown
2002-11-12 17:24:39 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please
Chris L
2002-11-12 21:58:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help a confused newbie out please