Re: Cost estimate for machining of acme screws

--- In CAD_CAM_EDM_DRO@y..., bjammin@i... wrote:
> At 09:45 PM 11/17/02 -0600, you wrote:
> >If you really want a slight interference fit for the bearings,
then
> >you'd better be prepared for
> >grinding it with a toolpost grinder. There's no way to repeatably
get
> >.0005" tolerance with
> >a pointed cutting tool!
>
> I do it repeatedly. Have held +/-.0002 on ODs for lots of ten-
twenty.
>
>
>
> Regards, Hoyt McKagen
>
> To prevent virus propogation, please don't put this addy in your
book
> Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
> Best MC - http://www.freeyellow.com/members/batwings/best.html
> Camping/Caving -
http://www.freeyellow.com/members/batwings/caving.html
> Two-Wheel-Tech List - http://batwings.freeyellow.com/2whfaq.html
> I thought I'd made a mistake once, but I was wrong