Re: [CAD_CAM_EDM_DRO] How do I rout a sharp inside corner?
Posted by
Les Watts
on 2002-11-28 05:20:50 UTC
From: "Brian Pitt" <bfp@...>
V-bit carving is an obvious way to get some inside corners on
limited shapes that I should have mentioned since I do it all the time
for sign lettering. A program to do this that fits hobbyist's budgets
is called vcarvz. It is available from Fred (IMservice) on this list
as a demo.
Other methods we have discussed must be used for vertical walls
or compound curves like cove molding.
Les
Leslie Watts
L M Watts Furniture
Tiger, Georgia USA
http://www.alltel.net/~leswatts/wattsfurniturewp.html
engineering page:
http://www.alltel.net/~leswatts/shop.html
Surplus cnc for sale:
http://www.alltel.net/~leswatts/forsale.html
> there was a thread on this here about year or two agoYes... good point . That could work with 3 axis and multiple setups.
> if you take a sharp pointed tool and tip it at a compound angle so
> that it reaches into the corner you can remove the radius from the
> corner of the pocket by plunging down and then out to the sides
> a 60deg tool tilted at 45deg from vertical in both X and Y will do it
> make a cone of paper and test fit it in the corner of a room to see
> how it works out
V-bit carving is an obvious way to get some inside corners on
limited shapes that I should have mentioned since I do it all the time
for sign lettering. A program to do this that fits hobbyist's budgets
is called vcarvz. It is available from Fred (IMservice) on this list
as a demo.
Other methods we have discussed must be used for vertical walls
or compound curves like cove molding.
Les
Leslie Watts
L M Watts Furniture
Tiger, Georgia USA
http://www.alltel.net/~leswatts/wattsfurniturewp.html
engineering page:
http://www.alltel.net/~leswatts/shop.html
Surplus cnc for sale:
http://www.alltel.net/~leswatts/forsale.html
Discussion Thread
echnidna
2002-11-27 15:15:53 UTC
How do I rout a sharp inside corner?
Les Watts
2002-11-27 17:12:31 UTC
Re: [CAD_CAM_EDM_DRO] How do I rout a sharp inside corner?
echnidna
2002-11-27 18:26:09 UTC
Re: How do I rout a sharp inside corner?
doug98105
2002-11-27 18:47:54 UTC
Re: How do I rout a sharp inside corner?
echnidna
2002-11-27 18:49:10 UTC
Re: How do I rout a sharp inside corner?
echnidna
2002-11-27 18:54:08 UTC
Re: How do I rout a sharp inside corner?
Brian Pitt
2002-11-28 00:53:17 UTC
Re: [CAD_CAM_EDM_DRO] How do I rout a sharp inside corner?
Les Watts
2002-11-28 05:20:50 UTC
Re: [CAD_CAM_EDM_DRO] How do I rout a sharp inside corner?
Fred Smith
2002-11-28 08:29:13 UTC
Re: How do I rout a sharp inside corner?