Re: Software Question...

Bill, are you going to use PM servos or brushless servos?
Mark

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "gadget_c <billsand@c...>"
<billsand@c...> wrote:

> I attempted this an hour or so ago and nothing happened - lets see
> what happens this time....
>
> Some software advertises that it is for stepper motors, some for
> servo motors. Doesn't the driver match the motor and control
> feedback from the encoder? I understand the open and closed loop

but

> how far back into the system does it go - into the software? I have
> the mill sorted out (and on the way), the servomotors and drivers

on

> the way but the software baffeles me with choices. I have some time
> to sort it out but some of you have been through this and I'm sure
> can offer educated suggestions!
>
> Thanks up front,
>
> Bill C.