Re: Software Question...
Posted by
gadget_c <billsand@c...
on 2002-12-15 19:40:09 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "gadget_c <billsand@c...>"
<billsand@c...> wrote:
encoder, the 'loop' closes at the driver? The software (Mach1
example) just keeps on plugging commands to a crashed machine/part?
Bill C.
<billsand@c...> wrote:
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Robert Campbell"<bob@c...>
> wrote:signals.
> > The cad and cam programs are independent of the type of drives
> (stepper or
> > servo). The Cam program in most cases puts out a G code (example
> G01).
> >
> > The G code then is read by a control program like Mach1. In
> today's PC world
> > the control program will just put out step and direction
> At thisSO, If the software does not receive a signal from the motor or
> > point things change. If you look at the gecko drives
> (www.geckodrive.com)
> > they have different boxes for stepper or servo.
> >
> > I hope that this helps.
> >
> > Bob Campbell
>
> Bob, I bought the G320's and I have looked about the Mach1 or
> Master5 CNC. Not really sure of the difference....
>
> Bill C.
encoder, the 'loop' closes at the driver? The software (Mach1
example) just keeps on plugging commands to a crashed machine/part?
Bill C.
Discussion Thread
gadget_c <billsand@c...
2002-12-15 19:02:49 UTC
Software Question...
natchamp_87 <mark@h...
2002-12-15 19:13:29 UTC
Re: Software Question...
Robert Campbell
2002-12-15 19:13:46 UTC
Re: [CAD_CAM_EDM_DRO] Software Question...
gadget_c <billsand@c...
2002-12-15 19:30:13 UTC
Re: Software Question...
gadget_c <billsand@c...
2002-12-15 19:34:01 UTC
Re: Software Question...
gadget_c <billsand@c...
2002-12-15 19:40:09 UTC
Re: Software Question...
jeffalanp <xylotex@h...
2002-12-15 20:02:39 UTC
Re: Software Question...
Ray Henry
2002-12-16 06:36:31 UTC
Re: Re: Software Question...