Re: Adding encoders to existing stepper system?

I second that opinion.
A well adjusted stepper system dose not
lose steps.
If there is a problem, fix the problem.
benefits of a stepper system is they are simple.
Adding encoders adds a new source for possible
problems to a system that is not running right
to start with.
besides you will limit yourself to a very small
choice of controllers that can be configured for
this.
Good Luck

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Tim Goldstein" <timg@k...>
wrote:

> Personally I think it is a bad idea to add encoders to solve the
> problem. A properly set up and adjusted stepper machine will not

lose

> steps unless you hit something or go too fast for the is

capabilities.

> You are wanting to throw on some encoders to magically fix what is

the

> true problem. I think your time/effort/money would be much better

spent

> figuring out the actual problem and fixing it. Then if you feel you

need

> encoders for some reason have at it. But in my mind it is much like
> putting a fancy paint job on a run down jalopy. It may make it look
> good, but does not address the basic issues.
>
> Just my $.02
>
> Tim
> [Denver, CO]
> Sherline products at Deep Discount
> Mach1 & DeskCNC with credit card ordering
> www.KTMarketing.com/Sherline
>
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html