Re: Camtronics/Gecko troubleshooting
Posted by
Monte Westlund <montejw@e...
on 2003-01-26 14:00:58 UTC
Tim and Bernard,
It seems as though I've got 3 motors with bad encoders. I had tried
a second motor earlier this morning and it acted the same as the
first so I thought, okay, it's normal. I just tried all 4 and only
found one that both channels worked on. I hooked it up and it
immediatly locked up like I think it's supposed to.
Thanks loads, the next round is on me,
Monte
It seems as though I've got 3 motors with bad encoders. I had tried
a second motor earlier this morning and it acted the same as the
first so I thought, okay, it's normal. I just tried all 4 and only
found one that both channels worked on. I hooked it up and it
immediatly locked up like I think it's supposed to.
Thanks loads, the next round is on me,
Monte
Discussion Thread
Monte Westlund <montejw@e...
2003-01-26 10:08:34 UTC
Camtronics/Gecko troubleshooting
Bernard R <bwjarandall@c...
2003-01-26 11:23:18 UTC
Re: Camtronics/Gecko troubleshooting
Monte Westlund <montejw@e...
2003-01-26 11:43:13 UTC
Re: Camtronics/Gecko troubleshooting
Bernard R <bwjarandall@c...
2003-01-26 13:22:13 UTC
Re: Camtronics/Gecko troubleshooting
Tim Goldstein
2003-01-26 13:22:37 UTC
RE: [CAD_CAM_EDM_DRO] Re: Camtronics/Gecko troubleshooting
Monte Westlund <montejw@e...
2003-01-26 14:00:58 UTC
Re: Camtronics/Gecko troubleshooting
Jon Elson
2003-01-26 17:53:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: Camtronics/Gecko troubleshooting
Monte
2003-01-26 17:58:40 UTC
Re: [CAD_CAM_EDM_DRO] Re: Camtronics/Gecko troubleshooting