Re: [CAD_CAM_EDM_DRO] Re: Camtronics/Gecko troubleshooting

>>Tim suggested I measure the voltage across enc- and each of the
>>phase wires. One side goes from 5v to 0 as I turn the shaft, the
>>other side stays fixed at 5v.
>>
>>
>OK, there's your problem. You can disconnect that wire from the drive,
>and see if the
>encoder works with the drive not loading it down. If so, something may
>have blown
>out that input on the drive. If not, then that output of the encoder is
>probably bad.
>Since one of the encoder phases is working, it is not a problem with
>needing a
>pull-up resistor or some similar thing.

Thanks Jon,
I've already got them boxed up to send back.

Monte