RE: [CAD_CAM_EDM_DRO] HELP ON CHOOSING A STEPPER MOTOR CONTROLLER

I am not familiar with the Alzanti. The HobbyCNC and the Stepperworld
units are old technology unipolar units. The Xylotex is a great unit. I
have 2 of them sitting next to me and they perform great. They are very
current technology with bipolar drives and up to 8x microstepping. If a
2.5 amp 35 v drive will do the job for you they are the best bang for
the buck available. Jeff is also a great guy to deal with.

Tim
[Denver CO]
Sherline Products at Deep Discount
Mach1 & DeskCNC with Credit Card ordering
Contact me for discounts on DeskCNC & Sherline bundles
www.KTMarketing.com/Sherline

> -----Original Message-----
> I am looking at the different 3 and 4 axis stepper motor
> controllers. I am specifically looking at the lower cost units
> which can be used for a hobbiest group to be a project.
>
> I have viewed a number of controllers but do not want to be fooled.
> Some of you out there know more than I do. I have limited my
> choices to the folowing manufactures and models:
> ALZANTI PVP2460
> HobbyCNC 4 axis controller
> Stepperworld FET-4
> XYLOTEX XS-3585/8S-3
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html