Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Posted by
Bill Higdon
on 2003-01-29 19:49:31 UTC
Duh, I should've read the header
Bill Higdon
Bill Higdon wrote:
Bill Higdon
Bill Higdon wrote:
> Alan,
> Who made them?
> Bill Higdon
> Alan Trest wrote:
>
>>Anyone on the list familiar with what appears to be a 4 motor
>>controller box. The Model is 340E0004-B. I was given two of them
>>and can't find anything on their website about them. They came out
>>of some type of X-Ray equipment. I believe they are servo motor
>>drivers but am not sure. Each side of the cube has a terminal strip
>>with 13 connectors,
>>Motor#1,Motor#3,1&3com, low volts, (ccw )dir. control, (cw) clock,
>>OVDC, Mode Select, output(s) off, High Volts, 2&4 com., motor#2,
>>motor#4.
>>
>>This is reversed on the other side terminal strip.
>>
>>Any help with these is appreciated.
>>
>>The only other writing on the cube is at the bottom. MOTOR DRIVER
>>TERMINAL BLOCK
>>
>>Thanks,
>>
>>Alan Trest
>>Pensacola Florida
Discussion Thread
Alan Trest <cncprojects0@h...
2003-01-29 16:01:26 UTC
Anaheim Automation Question
Chris L
2003-01-29 17:44:06 UTC
Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Alan Trest <cncprojects0@h...
2003-01-29 18:12:32 UTC
Re: Anaheim Automation Question
Mariss Freimanis <mariss92705@y...
2003-01-29 18:17:40 UTC
Re: Anaheim Automation Question
Bill Higdon
2003-01-29 18:46:56 UTC
Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Alan Trest <cncprojects0@h...
2003-01-29 19:14:39 UTC
Re: Anaheim Automation Question
Bill Higdon
2003-01-29 19:49:31 UTC
Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Alan Trest <cncprojects0@h...
2003-01-29 19:52:12 UTC
Re: Anaheim Automation Question
CL
2003-01-30 06:11:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Anaheim Automation Question
Bill Higdon
2003-01-30 07:53:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Anaheim Automation Question
ballendo <ballendo@y...
2003-01-31 07:17:56 UTC
Re: Anaheim Automation Question