Re: [CAD_CAM_EDM_DRO] Re: Anaheim Automation Question

ALan,
That's ok it was one of my "Rare" Homer Simpson moments.
Bill Higdon
Alan Trest wrote:

> Hi Bill,
>
> I was not making fun, just forgot to put the vendor in the message,
> it was my mistake.
>
> Thanks,
>
> Alan--- In CAD_CAM_EDM_DRO@yahoogroups.com, Bill Higdon
> <w.higdon@a...> wrote:
>
>>Duh, I should've read the header
>>Bill Higdon
>>Bill Higdon wrote:
>>
>>>Alan,
>>>Who made them?
>>>Bill Higdon
>>>Alan Trest wrote:
>>>
>>>
>>>>Anyone on the list familiar with what appears to be a 4 motor
>>>>controller box. The Model is 340E0004-B. I was given two of
>>>
> them
>
>>>>and can't find anything on their website about them. They came
>>>
> out
>
>>>>of some type of X-Ray equipment. I believe they are servo motor
>>>>drivers but am not sure. Each side of the cube has a terminal
>>>
> strip
>
>>>>with 13 connectors,
>>>>Motor#1,Motor#3,1&3com, low volts, (ccw )dir. control, (cw)
>>>
> clock,
>
>>>>OVDC, Mode Select, output(s) off, High Volts, 2&4 com., motor#2,
>>>>motor#4.
>>>>
>>>>This is reversed on the other side terminal strip.
>>>>
>>>>Any help with these is appreciated.
>>>>
>>>>The only other writing on the cube is at the bottom. MOTOR
>>>
> DRIVER
>
>>>>TERMINAL BLOCK
>>>>
>>>>Thanks,
>>>>
>>>>Alan Trest
>>>>Pensacola Florida