Re: Anaheim Automation Question
Posted by
Alan Trest <cncprojects0@h...
on 2003-01-29 19:52:12 UTC
Hi Bill,
I was not making fun, just forgot to put the vendor in the message,
it was my mistake.
Thanks,
Alan--- In CAD_CAM_EDM_DRO@yahoogroups.com, Bill Higdon
<w.higdon@a...> wrote:
I was not making fun, just forgot to put the vendor in the message,
it was my mistake.
Thanks,
Alan--- In CAD_CAM_EDM_DRO@yahoogroups.com, Bill Higdon
<w.higdon@a...> wrote:
> Duh, I should've read the headerthem
> Bill Higdon
> Bill Higdon wrote:
> > Alan,
> > Who made them?
> > Bill Higdon
> > Alan Trest wrote:
> >
> >>Anyone on the list familiar with what appears to be a 4 motor
> >>controller box. The Model is 340E0004-B. I was given two of
> >>and can't find anything on their website about them. They cameout
> >>of some type of X-Ray equipment. I believe they are servo motorstrip
> >>drivers but am not sure. Each side of the cube has a terminal
> >>with 13 connectors,clock,
> >>Motor#1,Motor#3,1&3com, low volts, (ccw )dir. control, (cw)
> >>OVDC, Mode Select, output(s) off, High Volts, 2&4 com., motor#2,DRIVER
> >>motor#4.
> >>
> >>This is reversed on the other side terminal strip.
> >>
> >>Any help with these is appreciated.
> >>
> >>The only other writing on the cube is at the bottom. MOTOR
> >>TERMINAL BLOCK
> >>
> >>Thanks,
> >>
> >>Alan Trest
> >>Pensacola Florida
Discussion Thread
Alan Trest <cncprojects0@h...
2003-01-29 16:01:26 UTC
Anaheim Automation Question
Chris L
2003-01-29 17:44:06 UTC
Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Alan Trest <cncprojects0@h...
2003-01-29 18:12:32 UTC
Re: Anaheim Automation Question
Mariss Freimanis <mariss92705@y...
2003-01-29 18:17:40 UTC
Re: Anaheim Automation Question
Bill Higdon
2003-01-29 18:46:56 UTC
Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Alan Trest <cncprojects0@h...
2003-01-29 19:14:39 UTC
Re: Anaheim Automation Question
Bill Higdon
2003-01-29 19:49:31 UTC
Re: [CAD_CAM_EDM_DRO] Anaheim Automation Question
Alan Trest <cncprojects0@h...
2003-01-29 19:52:12 UTC
Re: Anaheim Automation Question
CL
2003-01-30 06:11:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Anaheim Automation Question
Bill Higdon
2003-01-30 07:53:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Anaheim Automation Question
ballendo <ballendo@y...
2003-01-31 07:17:56 UTC
Re: Anaheim Automation Question