Re: [CAD_CAM_EDM_DRO] Harrison Lathe and Gecko's

Hi Terry

Have a talk with Technical Support at Harrison (01924 415010) - The guys up
there are quite helpfull and may be able to tell you who made the amps and
where to get them repaired. I needed similar info a few years ago with my
Boxford, which is now part of the Harrison Group I believe.

If you are still stuck, give me a shout off list - I'm sure it could be fixed.

Regards, Paul.

On Wednesday 05 Feb 2003 11:20 pm, James Owens wrote:
> I have a Harrison 280 CNC/Trainer Lathe with a blown Z amp. The motor is a
> four wire stepper and the board connections are motor clock, motor
> direction, +85 volts DC @ 10 amps, +24 volts DC, 0 volts and Drive Enable.

> I cannot identify any of the components on the board except the logic even
> with the help of the internet and a circuit diagram is out of the question
> because I don't know the board manufacturer.

--

The spamming scumbags have won - A new email account is now in use with a
mangled return address. Send replies to :
paul AT bdiemc DOT fslife DOT co DOT uk
Or :
bdi-emc AT ntlworld DOT com