CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Max feedrate

Posted by CL
on 2003-02-18 08:42:55 UTC
turbulatordude wrote:

>Isn't max feed rate a calculation of cutter tip speed, material, and
>depth of cut ?
>
Yes, In that sense....

. However, the earlier question in this thread was in regards the
"setting" of max feedrates in a controller itself.
More along the lines of Machine-motor tuning if you get what I mean.

CL

Discussion Thread

andrewyslee <andrewlee@s... 2003-02-16 20:20:15 UTC Max feedrate CL 2003-02-17 07:18:21 UTC Re: [CAD_CAM_EDM_DRO] Max feedrate knives01us <knives01@a... 2003-02-17 08:45:09 UTC Re: Max feedrate CL 2003-02-17 13:34:02 UTC Re: [CAD_CAM_EDM_DRO] Re: Max feedrate andrewyslee <andrewlee@s... 2003-02-18 02:55:32 UTC Re: Max feedrate andrewyslee <andrewlee@s... 2003-02-18 03:01:07 UTC Re: Max feedrate CL 2003-02-18 06:11:15 UTC Re: [CAD_CAM_EDM_DRO] Re: Max feedrate CL 2003-02-18 06:38:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Max feedrate turbulatordude <davemucha@j... 2003-02-18 08:32:20 UTC Re: Max feedrate CL 2003-02-18 08:42:55 UTC Re: [CAD_CAM_EDM_DRO] Re: Max feedrate Matt Shaver 2003-02-18 13:02:13 UTC Re: [CAD_CAM_EDM_DRO] Re: Max feedrate CL 2003-02-21 02:52:01 UTC Re: [CAD_CAM_EDM_DRO] Re: Max feedrate forumtvm <forumtvm@y... 2003-02-23 08:27:43 UTC Re: Max feedrate