Re: stepper
Posted by
turbulatordude <davemucha@j...
on 2003-02-21 17:49:21 UTC
1-6 and 3
1 and 6 are the highest resistance so are at ends. 3 is the center
2-4 and 5
2 is the center
4 to 5 are the high resistance so are the ends.
series is 1 to 6 for one circuit and 4 to 5 on the other.
For single coil, 3 to 1 OR 3 to 6 for one coil
For the other coil of a single coil, 2 to 4 OR 2 to 5.
Isolate the unused wires, do not connect them to anything.
Dave
1 and 6 are the highest resistance so are at ends. 3 is the center
2-4 and 5
2 is the center
4 to 5 are the high resistance so are the ends.
series is 1 to 6 for one circuit and 4 to 5 on the other.
For single coil, 3 to 1 OR 3 to 6 for one coil
For the other coil of a single coil, 2 to 4 OR 2 to 5.
Isolate the unused wires, do not connect them to anything.
Dave
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Gene <capper@i...> wrote:
> I have a nema 42 stepper motor and I was wondering if anyone can
make
> sense of the wiring. It has 6 terminal screws and with the O meter
set
> to 200 heres what I get.
> term.1 to term.3--1.9 ohms
> term.1 to term.6--1.3 ohms
> term.2 to term.4--1.3 ohms
> term.2 to term.5--1.3 ohms
> term.3 to term.1--1.9 ohms
> term.3 to term.6--1.3 ohms
> term.4 to term.5--1.9 ohms
> term.4 to term.2--1.3 ohms
> term.5 to term.2--1.3 ohms
> term.5 to term.4--1.9 ohms
> term.6 to term.3--1.3 ohms
> term.6 to term.1--1.3 ohms
>
> I am wondering which is the full coil and which is the half coil.
Discussion Thread
Gene
2002-07-25 22:40:10 UTC
stepper
Jon Elson
2002-07-26 21:43:59 UTC
Re: [CAD_CAM_EDM_DRO] stepper
Gene
2003-02-21 17:39:46 UTC
stepper
turbulatordude <davemucha@j...
2003-02-21 17:49:21 UTC
Re: stepper
Jefferson H. Tomlinson <jeffersont@a...
2003-02-21 19:29:46 UTC
Re: stepper
Gene
2003-02-22 12:56:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: stepper
Gene
2004-05-21 15:57:38 UTC
stepper
Roy J. Tellason
2004-05-21 16:23:19 UTC
Re: [CAD_CAM_EDM_DRO] stepper
Gene
2004-05-21 17:37:30 UTC
Re: [CAD_CAM_EDM_DRO] stepper
Roy J. Tellason
2004-05-21 18:02:22 UTC
Re: [CAD_CAM_EDM_DRO] stepper