Re: Cannot Jog w/Turbo CNC

Yes sir, I think they are all the same. The only thing I'm not sure
of is "low active" Settings? What is low active and dir pin state
and step pin state?

Thanks...

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Tim Goldstein" <timg@k...>
wrote:

> Have you verified that you have the proper pin assignments in

TurboCNC

> to match those you are using in Mach1?
>
> Tim
> [Denver, CO]
> Sherline products at Deep Discount
> Mach1 & DeskCNC with credit card ordering
> www.KTMarketing.com/Sherline
> Now selling Visual Mill
>
>
> > -----Original Message-----
> >
> >
> > I'm about finished with the building of my first CNC router.
> > I've been playing with Turbo CNC but can't get it to jog my
> > motors. If I move to MACH1 program I am able to jog and run
> > the code. I've checked over the setting for each axis in
> > turbo CNC but there must be a setting I'm missing. I'm using
> > gecko 201's with a AXXUS controller. I used the formula
> > editor in Turbo CNC to set the steps/in and have even raised
> > that number to see if it had any affect. The are holding but
> > do not move. Any suggestions would be appreciated. Pictures
> > and drawings are coming soon.
> >
> > Thanks,
> >
> > Barclay
> >
> > FAQ: http://www.ktmarketing.com/faq.html