Re: [CAD_CAM_EDM_DRO] 555 step generator
Posted by
Alan Marconett KM6VV
on 2003-04-10 17:48:30 UTC
Hi Chris,
My pleasure!
Alan KM6VV
Chris Brick wrote:
My pleasure!
Alan KM6VV
Chris Brick wrote:
>
> > The R/C timing circuit of a 555 can include a pot. One thing that I do
> > is use a waveform generator, and set the duty cycle of a square wave to
> > resemble that of a controller program. But why not just generate
> > "moves" with a controller program on a PC? TurboCNC would probably fit
> > the bill.
>
> I could do that if it were going to be in my shop but the polisher is
> going in a lab and should take up a minimum of space and be simple to
> run.
>
> > No point trying to build a very elaborate "test box" out of a 555 timer
> > chip. Design a test box using a PIC. Pot, A/D converter, and a little
> > code.
>
> Now that's a good idea, don't know why it didn't cross my mind. I've
> got everything I need to do that. This will allow me to put a timer in
> the circuit as well so I can shut down the polisher and then the stepper
> when someone leaves it on for a week.
>
> Thanks for the tip, Alan.
>
> Chris
Discussion Thread
Chris Brick
2003-04-09 12:57:16 UTC
555 step generator
Alan Marconett KM6VV
2003-04-09 13:24:28 UTC
Re: [CAD_CAM_EDM_DRO] 555 step generator
turbulatordude
2003-04-09 16:02:31 UTC
Re: 555 step generator
caudlet
2003-04-10 08:22:00 UTC
Re: 555 step generator
wanliker@a...
2003-04-10 13:08:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: 555 step generator
Chris Brick
2003-04-10 14:54:08 UTC
Re: [CAD_CAM_EDM_DRO] 555 step generator
Alan Marconett KM6VV
2003-04-10 15:42:37 UTC
Re: [CAD_CAM_EDM_DRO] 555 step generator
Chris Brick
2003-04-10 15:54:46 UTC
Re: [CAD_CAM_EDM_DRO] 555 step generator
Alan Marconett KM6VV
2003-04-10 17:48:30 UTC
Re: [CAD_CAM_EDM_DRO] 555 step generator
caudlet
2003-04-11 14:40:54 UTC
Re: 555 step generator