Re: [CAD_CAM_EDM_DRO] cable suppliers - and the archives

At 05:33 PM 5/3/03 -0000, Dave wrote:

>My steppers are 5 amps each, so I can get by with less than 18ga.

Dave, go to http://www.meci.com, browse to Wire / Industrial Control Wire
and you will find a goldmine of Belden Infinity cable, supremely flexible
and rated for millions of flex cycles. I use the 20 gage on my Sherlines
and gantry, and a friend is using the 4-conductor 16-gage on his mill
drill. It's good, cheap, and bright yellow! :-)

Best regards,

Randy

Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com