Re: [CAD_CAM_EDM_DRO] Is there a way to drill holes with a router?
Posted by
Carl Mikkelsen
on 2003-05-31 13:32:53 UTC
Raul,
I do this frequently in aluminum. My current machine is using a laminate
trimmer (30K RPM), but the next will use the PC 5-speed router.
I use a small carbide 2-flute end-mill cutter, typically between 1/16" and
1/8". I use a slow z-axis feed to penetrate the material, and them mill
out the hole to the desired size.
I used this a lot recently to drill tap-holes for 10-24 screws for NEMA23
motor mounts. I needed to have the holes be accurately located with
respect to the shaft hole and the motor collar. It was far easier to use
the same cutter and setup, rather than doing the work on two machines.
-- Carl
I do this frequently in aluminum. My current machine is using a laminate
trimmer (30K RPM), but the next will use the PC 5-speed router.
I use a small carbide 2-flute end-mill cutter, typically between 1/16" and
1/8". I use a slow z-axis feed to penetrate the material, and them mill
out the hole to the desired size.
I used this a lot recently to drill tap-holes for 10-24 screws for NEMA23
motor mounts. I needed to have the holes be accurately located with
respect to the shaft hole and the motor collar. It was far easier to use
the same cutter and setup, rather than doing the work on two machines.
-- Carl
Discussion Thread
ralaco
2003-05-31 12:05:39 UTC
Is there a way to drill holes with a router?
Robert Campbell
2003-05-31 13:27:48 UTC
Re: [CAD_CAM_EDM_DRO] Is there a way to drill holes with a router?
Carl Mikkelsen
2003-05-31 13:32:53 UTC
Re: [CAD_CAM_EDM_DRO] Is there a way to drill holes with a router?
ralaco
2003-05-31 14:31:31 UTC
Re: Is there a way to drill holes with a router?
Tim Goldstein
2003-05-31 15:10:03 UTC
RE: [CAD_CAM_EDM_DRO] Re: Is there a way to drill holes with a router?
turbulatordude
2003-05-31 15:11:21 UTC
Re: Is there a way to drill holes with a router?
Robert Campbell
2003-05-31 18:54:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Is there a way to drill holes with a router?
wanliker@a...
2003-05-31 22:50:05 UTC
Is there a way to drill holes with a router?