Re: [CAD_CAM_EDM_DRO] Re: Is there a way to drill holes with a router?

Raul,

With a 3/16 cutter I usually cut at 15 IPM. I generally stay on the low
side.


Bob Campbell

----- Original Message -----
From: "ralaco" <ralaco@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, May 31, 2003 2:31 PM
Subject: [CAD_CAM_EDM_DRO] Re: Is there a way to drill holes with a router?


> Thank you Bob and Carl:
>
> To mill out holes between 1/4" and 3/8" diam in a 1/4" thick aluminum
> plank
> with a 1/8" end-mill cutter, what feed speed should I set?
>
> Raul Lara
>
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "ralaco" <ralaco@y...> wrote:
> > Can I use drill bits with a router? If so what speed I must use
> with
> > a 3.25 Hp 5 Speed Porter Cable Router?
> >
> > I need to drill different hole sizes in a aluminum and acrylic
> plates
> > and then, cutout some circles from the same plates.
> >
> > I'm asking this because the router speed is much more higher than a
> > drill.
> >
> > Raul Lara
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>