RE: [CAD_CAM_EDM_DRO] Re: Is there a way to drill holes with a router?

Just a little reminder before this veers off topic. Speeds and feeds are
considered a general machining discussion and are off topic for this
list. There are a number of resources like Machinery Handbook and
Armchair Machinist as well as various sites that list speeds and feeds.

On this list the original question of how to drill the hole with your
router was appropriate, but the speed and feed portion is not.

Any comments or input off list to CAD_CAM_EDM_DRO-owner@yahoogroups.com

Thanks for keeping this group focused.

Tim
[Denver CO]

> -----Original Message-----
>
> Thank you Bob and Carl:
>
> To mill out holes between 1/4" and 3/8" diam in a 1/4" thick aluminum
> plank
> with a 1/8" end-mill cutter, what feed speed should I set?
>
> Raul Lara