Re: EMC w/steppers & Xylotex

Hi Ken,
If you have things runnings with freqmod, stick with it. There is
a nuance (bug?) in the steppermod code that needs to be addressed
that I'm told doesn't exist in freqmod. I just mentioned steppermod
because it is the one I had modified to swap the step & dir.
Remeber that you will need to wire over the GND pins in your cross-
over cable. The driver board only actively uses DB25 pins 2-7, all
others signal pins are passed through to one of the two Molex
headers, so these do not necessarily need to be wired up. If you are
going to add a 4th axis and use the 4th axis add-on cable then you
would want to wire DB25 pins 8 & 9 over (and cross).

Jeff
http://www.xylotex.com

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "kdntool" <gjetson41@h...>
wrote:

> Again Thank you for your help !! I did pick up on the different
> pinouts while I was getting everything together so I have already
> made and installed ythe "crossover" cable. I am not a programmer by
> any means so that was the route I chose. I did however use

freqmod.o

> instead of steppermod.o and maybe that is my problem. I will change
> it now and find out.
> Regards,
> Ken