Re: CNC controller board and software for servo motor cnc

>--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Fred Smith" <imserv@v...> >
> We are about 2 weeks from releasing a cnc-control, servo retrofit
>kit
> for desktop mills with DeskCNC software, controller board, 3 servo
> drivers, 3 motors w/encoders and NEMA 23 mounting plates for under
> $700 retail. Add in about $70 of misc electronics and a CNC ready
> desktop mill and end up with a CNC servo mill for about $1500. Bye
> Bye steppers.
>
> Best Regards, Fred Smith- IMService

Fred,
Sounds good, in fact it sounds very good.
Can the servo version of DeskCNC handle different pitch screws for
the X, Y and Z yet or is this still on the cards.
Just checked your web site for a list of G codes for DeskCNC but it's
down at present. Are G41/42 and G43/44 implemented as yet?

John S.