CAD CAM EDM DRO - Yahoo Group Archive

Re: err/res circuit(updated picture)

Posted by cnchomeman
on 2003-07-17 17:33:56 UTC
> You have +5 V going through a relay contact and then to the base of
an
> NPN transistor. You need to put a series resistor (say, 10 K Ohms)
in
> series with the wire to the base, or it will draw lots of current
and
> destroy the transistor (and possibly the drive, too).
>
> Jon

You may be correct, but I stole this part of the circuit directly
from the geckodrive manual, as can be seen on the geckodrive
website. Here is an image of the curcuit. Is this a typo? Should I
put the resistor in?

http://www.e-zflight.com/files/ncnczj.jpg

Eric

Discussion Thread

cnchomeman 2003-07-16 12:32:49 UTC err/res circuit cnchomeman 2003-07-16 12:44:39 UTC Re: err/res circuit(updated picture) caudlet 2003-07-16 16:36:00 UTC Re: err/res circuit(updated picture) cnchomeman 2003-07-16 17:23:36 UTC Re: err/res circuit(updated picture) Jon Elson 2003-07-17 09:53:01 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) Jon Elson 2003-07-17 10:11:00 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) Jon Elson 2003-07-17 10:12:44 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) cnchomeman 2003-07-17 17:33:56 UTC Re: err/res circuit(updated picture) Jon Elson 2003-07-18 09:33:33 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) cnchomeman 2003-07-18 09:39:11 UTC Re: err/res circuit(updated picture) caudlet 2003-07-18 15:06:17 UTC Re: err/res circuit(updated picture) James Cullins 2003-07-19 18:41:29 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) andyolney 2003-07-21 09:09:36 UTC Re: err/res circuit(updated picture) James Cullins 2003-07-21 11:11:33 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) James Cullins 2003-07-21 19:46:36 UTC Re: [CAD_CAM_EDM_DRO] Re: err/res circuit(updated picture) cnchomeman 2003-07-23 21:44:26 UTC Re: err/res circuit(updated picture)