CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320

Posted by Vince Negrete
on 2003-07-22 23:59:24 UTC
>
>
> Mariss Freimanis wrote:
>
>>Eric,
>>
>>Shutting of the AC is the best way. Switching the DC to the drives is
>> the worst way.
>>
>>
>>
> How about throwing a fairly heavy drain resistor across the capacitor
> bank to drain it more quickly, and brake the motors if they are still
> moving? Using the NC contacts of a relay held in by the AC supply would
> do that.
>

ha! Great idea Jon! I'm glad you thought of it. Thanks... :) <kidding..>

Think Mariss was talking against using the Gecko to do DC shutdowns.
Also, unless there is a negative Polarity I dont see how it can "Brake"
any motors. Motors will just Coast in that situation.

Vince

Discussion Thread

cnchomeman 2003-07-22 07:19:40 UTC How to blow a Gecko 320 Vince Negrete 2003-07-22 08:03:06 UTC Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320 cnchomeman 2003-07-22 10:01:44 UTC Re: How to blow a Gecko 320 Mariss Freimanis 2003-07-22 16:23:55 UTC Re: How to blow a Gecko 320 Jon Elson 2003-07-22 23:05:05 UTC Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 Vince Negrete 2003-07-22 23:59:24 UTC Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 Jon Elson 2003-07-23 09:44:23 UTC Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 cnchomeman 2003-07-23 09:53:03 UTC Re: How to blow a Gecko 320 Mariss Freimanis 2003-07-23 13:52:05 UTC Re: How to blow a Gecko 320 Mariss Freimanis 2003-07-23 13:58:10 UTC Re: How to blow a Gecko 320 Chris Baugher 2003-07-23 17:01:33 UTC Braking resistors, WAS Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 Bill Kichman 2003-09-22 21:47:11 UTC Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320