Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Posted by
Jon Elson
on 2003-07-22 23:05:05 UTC
Mariss Freimanis wrote:
bank to drain it more quickly, and brake the motors if they are still
moving? Using the NC contacts of a relay held in by the AC supply
would do that.
Jon
>Eric,How about throwing a fairly heavy drain resistor across the capacitor
>
>Shutting of the AC is the best way. Switching the DC to the drives is
>the worst way.
>
>
>
bank to drain it more quickly, and brake the motors if they are still
moving? Using the NC contacts of a relay held in by the AC supply
would do that.
Jon
Discussion Thread
cnchomeman
2003-07-22 07:19:40 UTC
How to blow a Gecko 320
Vince Negrete
2003-07-22 08:03:06 UTC
Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320
cnchomeman
2003-07-22 10:01:44 UTC
Re: How to blow a Gecko 320
Mariss Freimanis
2003-07-22 16:23:55 UTC
Re: How to blow a Gecko 320
Jon Elson
2003-07-22 23:05:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Vince Negrete
2003-07-22 23:59:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Jon Elson
2003-07-23 09:44:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
cnchomeman
2003-07-23 09:53:03 UTC
Re: How to blow a Gecko 320
Mariss Freimanis
2003-07-23 13:52:05 UTC
Re: How to blow a Gecko 320
Mariss Freimanis
2003-07-23 13:58:10 UTC
Re: How to blow a Gecko 320
Chris Baugher
2003-07-23 17:01:33 UTC
Braking resistors, WAS Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Bill Kichman
2003-09-22 21:47:11 UTC
Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320