Braking resistors, WAS Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Posted by
Chris Baugher
on 2003-07-23 17:01:33 UTC
On Wed, 23 Jul 2003, Mariss Freimanis wrote:
was planning on putting them between the drive and the motor. Would it be
better to put them between the drive and the power supply? Or is there
not much difference?
C|
> The motor will then act as a generator (that's OK) and will "power"I'm going to add E-stop braking resistors to the mill I'm converting. I
> the power supply until its kinetic energy is dissipated.
was planning on putting them between the drive and the motor. Would it be
better to put them between the drive and the power supply? Or is there
not much difference?
C|
Discussion Thread
cnchomeman
2003-07-22 07:19:40 UTC
How to blow a Gecko 320
Vince Negrete
2003-07-22 08:03:06 UTC
Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320
cnchomeman
2003-07-22 10:01:44 UTC
Re: How to blow a Gecko 320
Mariss Freimanis
2003-07-22 16:23:55 UTC
Re: How to blow a Gecko 320
Jon Elson
2003-07-22 23:05:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Vince Negrete
2003-07-22 23:59:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Jon Elson
2003-07-23 09:44:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
cnchomeman
2003-07-23 09:53:03 UTC
Re: How to blow a Gecko 320
Mariss Freimanis
2003-07-23 13:52:05 UTC
Re: How to blow a Gecko 320
Mariss Freimanis
2003-07-23 13:58:10 UTC
Re: How to blow a Gecko 320
Chris Baugher
2003-07-23 17:01:33 UTC
Braking resistors, WAS Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320
Bill Kichman
2003-09-22 21:47:11 UTC
Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320