CAD CAM EDM DRO - Yahoo Group Archive

Re: How to blow a Gecko 320

on 2003-07-23 13:52:05 UTC
Eric,

The motor will then act as a generator (that's OK) and will "power"
the power supply until its kinetic energy is dissipated.

Mariss

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "cnchomeman"
<cnchomeman@y...> wrote:
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mariss Freimanis"
> <mariss92705@y...> wrote:
> > Eric,
> >
> > Shutting of the AC is the best way. Switching the DC to the
drives
> is
> > the worst way.
> >
> > Mariss
> >
>
> Mariss,
>
> You would know! That's how I am doing it, but I wanted to be
sure.
> My estop button shuts down all AC power. If the motors are moving
> when I hit estop, all will be well?
>
> Eric

Discussion Thread

cnchomeman 2003-07-22 07:19:40 UTC How to blow a Gecko 320 Vince Negrete 2003-07-22 08:03:06 UTC Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320 cnchomeman 2003-07-22 10:01:44 UTC Re: How to blow a Gecko 320 Mariss Freimanis 2003-07-22 16:23:55 UTC Re: How to blow a Gecko 320 Jon Elson 2003-07-22 23:05:05 UTC Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 Vince Negrete 2003-07-22 23:59:24 UTC Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 Jon Elson 2003-07-23 09:44:23 UTC Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 cnchomeman 2003-07-23 09:53:03 UTC Re: How to blow a Gecko 320 Mariss Freimanis 2003-07-23 13:52:05 UTC Re: How to blow a Gecko 320 Mariss Freimanis 2003-07-23 13:58:10 UTC Re: How to blow a Gecko 320 Chris Baugher 2003-07-23 17:01:33 UTC Braking resistors, WAS Re: [CAD_CAM_EDM_DRO] Re: How to blow a Gecko 320 Bill Kichman 2003-09-22 21:47:11 UTC Re: [CAD_CAM_EDM_DRO] How to blow a Gecko 320