Re: [CAD_CAM_EDM_DRO] Servo Amps $75

I saw that ad too and called them. They first said they were out of them but
decided to do a check. They are not yet available was the second answer.
Dan
-----Original Message-----
From: Roger Brower <rbrower@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Thursday, March 23, 2000 7:38 AM
Subject: [CAD_CAM_EDM_DRO] Servo Amps $75

>From: Roger Brower <rbrower@...>
>
>Front page of H&R flyer, 5 amp 24 volt
>servo motor control board, $75 Is this
>the type ot thing for CNC?
>
>
>------------------------------------------------------------------------
>GET A NEXTCARD VISA, in 30 seconds! Get rates as low as 0.0%
>Intro or 9.9% Fixed APR and no hidden fees. Apply NOW!
>http://click.egroups.com/1/937/2/_/423600/_/953825899/
>------------------------------------------------------------------------
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>