Re: [CAD_CAM_EDM_DRO] Servo Amps $75

But back to the original question -

If they were available, would this be adequate for CNC and what size of
Mill for example could this size of amp drive?

Mike

Dan Mauch wrote:

>
> From: "Dan Mauch" <dmauch@...>
>
> I saw that ad too and called them. They first said they were out of them but
> decided to do a check. They are not yet available was the second answer.
> Dan
> -----Original Message-----
> From: Roger Brower <rbrower@...>
> To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
> Date: Thursday, March 23, 2000 7:38 AM
> Subject: [CAD_CAM_EDM_DRO] Servo Amps $75
>
> >From: Roger Brower <rbrower@...>
> >
> >Front page of H&R flyer, 5 amp 24 volt
> >servo motor control board, $75 Is this
> >the type ot thing for CNC?
> >
> >
> >------------------------------------------------------------------------
> >GET A NEXTCARD VISA, in 30 seconds! Get rates as low as 0.0%
> >Intro or 9.9% Fixed APR and no hidden fees. Apply NOW!
> >http://click.egroups.com/1/937/2/_/423600/_/953825899/
> >------------------------------------------------------------------------
> >
> >Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems in the above catagories.
> >To Unsubscribe, read archives, change to or from digest.
> >Go to: http://www.onelist.com/isregistered.cgi
> >Log on, and you will go to Member Center, and you can make changes there.
> >For the FAQ, go to http://www.ktmarketing.com/faq.html
> >bill,
> >List Manager
> >
> >
>
> ------------------------------------------------------------------------
> PERFORM CPR ON YOUR APR!
> Get a NextCard Visa, in 30 seconds! Get rates as low as
> 0.0% Intro or 9.9% Fixed APR and no hidden fees.
> Apply NOW!
> http://click.egroups.com/1/2121/2/_/423600/_/953830315/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager