Re: [CAD_CAM_EDM_DRO] Servo Amps $75

Mike Gann wrote:

> From: Mike Gann <mikegann@...>
>
> But back to the original question -
>
> If they were available, would this be adequate for CNC and what size
> of
> Mill for example could this size of amp drive?
> > >From: Roger Brower <rbrower@...>
> > >
> > >Front page of H&R flyer, 5 amp 24 volt
> > >servo motor control board, $75 Is this
> > >the type ot thing for CNC?

Certainly not a Bridgeport. I'm running 1/8 Hp motors, and they just
enough.
The peak I've got them set to right now is about 300 W (5 A at 60 V)
and I can get up to 95 IPM reliably. I think I can make it all the way
to
120 IPM with a little more tuning, but 95 is OK so far.

120 W might be OK for a Taig, Sherline or similar machine.

Jon