CAD CAM EDM DRO - Yahoo Group Archive

About 5-wire 5-phase Vexta motors

Posted by neojav_3000
on 2003-09-25 00:08:45 UTC
Hi everybody! I just got a used 5-wire 5-phase Vexta motor. I need it
for a school project. But I need to know if it can be handled by a
microcontroler o PC, is it possible? I thought only a bit pattern
into each of the 5 wires will do the work, is it correct?

Thanks for any help, I'm new at this!
=D
JAV

Discussion Thread

neojav_3000 2003-09-25 00:08:45 UTC About 5-wire 5-phase Vexta motors Harvey White 2003-09-25 08:20:47 UTC Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors Tony Jeffree 2003-09-25 09:19:18 UTC Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors Harvey White 2003-09-25 09:45:15 UTC Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors Jon Elson 2003-09-25 10:12:42 UTC Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors Tony Jeffree 2003-09-25 13:59:34 UTC Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors