Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors
Posted by
Harvey White
on 2003-09-25 08:20:47 UTC
On Wed, 24 Sep 2003 22:33:59 -0000, you wrote:
logic level signals you generate and make them drive the motor. You
will have to use darlington or FET transistors to do this, but I'm not
personally familiar with 5 phase motors. I'd go to their website for
all the information I could find, and pay special attention to the
parts that tell you how to drive the motor.
The actual program in a microcontroller is going to be relatively
simple, involving the timer/counter part of the chip, 5 output lines,
and some input lines to tell the chip what you want to do.
Harvey
>Hi everybody! I just got a used 5-wire 5-phase Vexta motor. I need itMicrocontroller or PC will do the job, but you will have to take the
>for a school project. But I need to know if it can be handled by a
>microcontroler o PC, is it possible? I thought only a bit pattern
>into each of the 5 wires will do the work, is it correct?
>
logic level signals you generate and make them drive the motor. You
will have to use darlington or FET transistors to do this, but I'm not
personally familiar with 5 phase motors. I'd go to their website for
all the information I could find, and pay special attention to the
parts that tell you how to drive the motor.
The actual program in a microcontroller is going to be relatively
simple, involving the timer/counter part of the chip, 5 output lines,
and some input lines to tell the chip what you want to do.
Harvey
>Thanks for any help, I'm new at this!
>=D
>JAV
>
>
>
Discussion Thread
neojav_3000
2003-09-25 00:08:45 UTC
About 5-wire 5-phase Vexta motors
Harvey White
2003-09-25 08:20:47 UTC
Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors
Tony Jeffree
2003-09-25 09:19:18 UTC
Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors
Harvey White
2003-09-25 09:45:15 UTC
Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors
Jon Elson
2003-09-25 10:12:42 UTC
Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors
Tony Jeffree
2003-09-25 13:59:34 UTC
Re: [CAD_CAM_EDM_DRO] About 5-wire 5-phase Vexta motors